Omron E2E-X10MB1T18 2M OMS

Technical specifications

Manufacturer

Omron

Manufacturer part no.

E2E-X10MB1T18 2M OMS

Type

Proximity or photoelectric sensor

Application

Non-contact detection of metal targets in machinery, with installation and target conditions selected for the exact sensor.

Used with

A compatible sensor input or IO-Link interface, where specified, and a target suitable for inductive detection.

Size

M18

Mounting type

Non-flush

Sensing distance

10 mm

Output type

IO-Link, PNP

Operation mode

NO

Connection method

Cable

Material housing

Brass, nickel plated

Cable specifications

PVC (oil-resistant)

Cable length

2 m

IO-Link baud rate

COM3 (230.4 kbps)

Overall length of sensor

55.3 mm

Thread length

28 mm

Degree of protection (IP)

IP67/IP67G/IP69K

Technical documents (1)

• Omron E2E-NEXT specifications and ordering table

Key features

• M18 body
• Non-flush mounting
• 10 mm sensing distance
• IO-Link, PNP output
• 2 m cable

About the Omron E2E-X10MB1T18 2M OMS

This variant uses NO operation and a 2 m cable. Target material, mounting clearances and surrounding metal affect selection; verify the exact sensing conditions in the manufacturer documentation.

What is the E2E-X10MB1T18 2M OMS used for?

Non-contact detection of metal targets in machinery, with installation and target conditions selected for the exact sensor.

Lifecycle and successor

To be confirmed.

Before you order

What to photograph or confirm so the right unit is quoted.

Match the full ordering designation, cable length and sensor body size. Confirm output type, NO/NC mode, supply and receiving input requirements. Check target material, required sensing distance and surrounding-metal clearances. Verify thread length, overall length, cable material and environmental conditions. For IO-Link variants, confirm the master/interface and exact device configuration.