Kongsberg ACP

Technical specifications

Manufacturer

Kongsberg

Manufacturer part no.

ACP

Type

AutoChief Control Panel

Application

Bridge / ECR operator panel

Used with

Kongsberg AutoChief C20

Function

Main operator control panel for AutoChief C20, on the bridge and in the engine control room

Display

7-inch TFT colour, 854 x 480 pixels

Controls

Operation wheel plus six metal-film push-buttons, each with an LED

Supply voltage

18 to 32 V DC, ±5% ripple

Power consumption

20 W

Communication

2 x LAN 10/100 Mbit, 2 x CAN bus

Inputs

3 potentiometer channels, 3-wire, 20 kΩ with line check

Relay outputs

2 changeover relays, maximum inductive load 3 A at 24 V DC

Analogue input accuracy

±1%

Isolation

Power via DC/DC converter; I/O channels and CAN bus fully isolated

Housing

Aluminium, flush panel mounting

Dimensions

256 x 316 x 94 mm

Weight

4.2 kg

IP code

IP22

Operating temperature

-15 to +70 °C

Storage temperature

-25 to +70 °C

Type approval

DNV, LRS, BV, GL, RINA, NK, ABS, KR, PRS, MRS and CCS

Technical documents (1)

• Kongsberg datasheet 330150-A

Key features

• Main operator panel for AutoChief C20, on the bridge and in the engine control room
• 7-inch colour display, 854 x 480 pixels
• Operation wheel for menus, mode changes and configuration
• Six metal-film push-buttons, each with its own LED
• Two LAN and two CAN connections, all isolated
• Aluminium housing for flush console mounting

About the Kongsberg ACP

The Kongsberg AutoChief Control Panel (ACP) is the main operator panel of the AutoChief C20 propulsion control system. It has a 7-inch colour display that shows the main engine as graphic mimics, a large central operation wheel used to select and activate them, and six metal-film push-buttons for cancelling shut downs and slow downs, transferring control, sound off and alarm acknowledge. From the panel the operator sees engine RPM, command RPM, start air, load, alarms and the remote control state, and can change set point limits and system settings. Kongsberg declared the AutoChief C20 system obsolete on 17 June 2025, with AutoChief 600 as the upgrade.

What is the ACP used for?

The ACP is normally installed on the navigation bridge and in the engine control room, flush-mounted in the console. It is where the crew control the main engine remotely, transfer command between locations and handle remote control alarms. It connects to the rest of the AutoChief C20 system over two CAN buses and two LAN ports, and has three potentiometer inputs and two relay outputs.

Lifecycle and successor

Discontinued.

OEM successor: AutoChief 600

Before you order

What to photograph or confirm so the right unit is quoted.

ACP is a model name, not a part number, so read the item number and revision from the label on the back of the panel. Kongsberg's datasheet for the AutoChief C20 ACP is 330150. Send a label photo, the software version shown at start-up if available, where the panel is installed (bridge or engine control room) and the vessel name or IMO number.