Schneider Electric BMXAMO0210

Technical specifications

Manufacturer

Schneider Electric

Manufacturer part no.

BMXAMO0210

Type

Analog output module

Application

I/O module

Used with

Modicon M340 / X80 backplane

Range of product

Modicon X80

Product or component type

Analog output module

Electrical connection

20 ways 1 connector

Isolation between channels

Isolated

Measurement error

<= 0.2 % of full scale 0...60 °C; 0.1 % of full scale 25 °C

Temperature drift

30 ppm/°C

Recalibration

Factory calibrated

Minimum crosstalk attenuation

90 dB

Common mode rejection

100 dB

Isolation voltage

1400 V DC between channels and ground; 1400 V DC between channels and bus; 750 V DC between channels

Detection type

Open circuit 0...20 mA; Open circuit 4...20 mA; Short circuit +/- 10 V

Load impedance ohmic

= 1000 Ohm +/- 10 V

Output level

High level

Analogue output number

2

Analogue output type

Current: 0...20 mA; Current: 4...20 mA; Voltage: +/- 10 V

Analogue output resolution

15 bits + sign

Supply

Internal power supply via rack

Conversion time

<= 1 ms

Maximum conversion value

+/- 11.25 V +/- 10 V; 0...24 mA 0...20 mA; 0...24 mA 4...20 mA

Fallback mode

Predefined; Configurable

MTBF reliability

1300000 H

Operating altitude

0...2000 m; 2000...5000 m with derating factor

Status LED

1 LED (green) RUN; 1 LED per channel (green) channel diagnostic; 1 LED (red) ERR; 1 LED (red) I/O

Net weight

0.144 kg

Power consumption in W

2.1 W 24 V DC typical; 2.8 W 24 V DC maximum; 0.35 W 3.3 V DC typical; 0.48 W 3.3 V DC maximum

Technical documents (1)

• Schneider Electric product page BMXAMO0210

Key features

• IP degree of protection: IP20
• Net weight: 0.144 kg

About the Schneider Electric BMXAMO0210

The Schneider Electric BMXAMO0210 is an analog output module from Schneider Electric's Modicon X80 range, which Schneider names "isolated analog output module X80 - 2 outputs". Its product page gives 2 analogue outputs, Current: 0...20 mA, 20 ways 1 connector and 150 mA at 3.3 V DC consumption. Schneider Electric lists it as Active.

What is the BMXAMO0210 used for?

The BMXAMO0210 sits in a Modicon X80 rack and connects field signals to the controller, which reads or writes them each cycle.

Lifecycle and successor

Active.

Before you order

What to photograph or confirm so the right unit is quoted.

Check the reference BMXAMO0210 on the module's label, with its product version. Send us a photo of the label and we will confirm the details before quoting.