Schneider Electric BMXAMO0802H

Technical specifications

Manufacturer

Schneider Electric

Manufacturer part no.

BMXAMO0802H

Type

Analog output module

Application

I/O module

Used with

Modicon M340 / X80 backplane

Range of product

Modicon X80

Product or component type

Analog output module

Product specific application

For severe environments

Electrical connection

20 ways 1 connector

Isolation between channels

Non isolated

Measurement error

<= 0.45 % of full scale - 25...70 °C; 0.1 % of full scale 25 °C

Temperature drift

45 ppm/°C 0...20 mA; 45 ppm/°C 4...20 mA

Minimum crosstalk attenuation

80 dB

Common mode rejection

80 dB

Isolation voltage

1400 V DC between channels and ground; 1400 V DC between channels and bus

Detection type

Open circuit 4...20 mA; Short circuit 0...20 mA

Load impedance ohmic

<= 350 Ohm 0...20 mA; <= 350 Ohm 4...20 mA

Analogue output number

8

Analogue output type

Current: 0...20 mA; Current: 4...20 mA

Analogue output resolution

16 bits

Supply

Internal power supply via rack

Conversion time

<= 4 ms

Maximum conversion value

0...21 mA 0...20 mA; 0...21 mA 4...20 mA

Fallback mode

Configurable; Predefined

MTBF reliability

1500000 H

Operating altitude

0...2000 m; 2000...5000 m with derating factor

Status LED

1 LED (green) RUN; 1 LED per channel (green) channel diagnostic; 1 LED (red) ERR; 1 LED (red) I/O

Net weight

0.15 kg

Power consumption in W

3.6 W 24 V DC typical; 3.9 W 24 V DC maximum; 0.35 W 3.3 V DC typical; 0.48 W 3.3 V DC maximum

Current consumption

150 mA at 3.3 V DC; 135 mA at 24 V DC

Technical documents (1)

• Schneider Electric product page BMXAMO0802H

Key features

• IP degree of protection: IP20
• Net weight: 0.15 kg

About the Schneider Electric BMXAMO0802H

The Schneider Electric BMXAMO0802H is an analog output module from Schneider Electric's Modicon X80 range, which Schneider names "analog output module X80 - 8 outputs - severe". Its product page gives 8 analogue outputs, Current: 0...20 mA, 20 ways 1 connector and 150 mA at 3.3 V DC consumption. Schneider Electric lists it as Active.

What is the BMXAMO0802H used for?

The BMXAMO0802H sits in a Modicon X80 rack and connects field signals to the controller, which reads or writes them each cycle.

Lifecycle and successor

Active.

Before you order

What to photograph or confirm so the right unit is quoted.

Check the reference BMXAMO0802H on the module's label, with its product version. Send us a photo of the label and we will confirm the details before quoting.