Kongsberg 8100334 PSO-P

Technical specifications

Manufacturer

Kongsberg

Manufacturer part no.

8100334

Type

Power module

Application

Marine alarm, monitoring, PMS or propulsion system

Used with

Kongsberg K-Chief 500

Function

Switch-over unit between two independent 24 V DC supplies for redundant DPU power

Supply voltage

18 to 32 V DC

Inputs

Two 24 V DC inputs (1x10 and 2x10 ports)

Outputs

Five 24 V DC outputs, maximum 3 A each, with automatic fuse and manual reset

Output voltage

Equal to the highest voltage supplied to the module

Power consumption

Nominal 360 W at maximum load (5 x 3 A)

Alarm relays

Change-over relay outputs for power #1 and power #2 failure; max 3 A 230 V AC / 32 V DC inductive load

Isolation

No galvanic separation in module (power); relay outputs isolated

IP code

IP20

Mounting

In cabinet with minimum IP20

Environment

IACS E10; IEC 60945

Vibration

4 g

Operating temperature

-15 to +70 °C

Storage temperature

-25 to +70 °C

Humidity

Max. 96% RH non-condensing

Weight

1.1 kg

Type approvals

DNV, LRS, BV, GL, RINA, NK, ABS, KR, PRS, RMR, CCS

Technical documents (1)

• Kongsberg datasheet 340332-A

Key features

• Switches between two independent 24 V DC supplies
• Five 24 V DC outputs, 3 A each, with automatic fuses
• Relay alarms for loss of power #1 and power #2
• Output follows the highest supply voltage
• Approved by DNV, LRS, BV, ABS, NK and others
• Version for AutoChief and K-Chief systems

About the Kongsberg 8100334

The Kongsberg 8100334 PSO-P is a power switch-over unit that sits between two independent 24 V DC supplies and the distributed processing units (DPUs) of a Kongsberg automation system. It provides five 24 V DC outputs of up to 3 A, each protected by an automatic fuse with manual reset, and always outputs the higher of the two supply voltages, so the DPUs stay powered if one supply fails. Change-over relay outputs signal the loss of either supply to the alarm system. Kongsberg lists this version for use with the AutoChief propulsion control system and the K-Chief alarm, monitoring and control system.

What is the 8100334 used for?

The PSO-P is mounted inside an automation or propulsion control cabinet (minimum IP20) and feeds redundant 24 V DC power to the DPUs on K-Chief and AutoChief C20 installations. Every DPU connected to its outputs depends on it for power.

Lifecycle and successor

Legacy.

OEM successor: K-Chief lifecycle upgrade or retrofit, depending on the system

Before you order

What to photograph or confirm so the right unit is quoted.

Check the item number 8100334 and the PSO-P marking on the module label. Kongsberg documentation for this unit is datasheet 340332. Send a label photo and the system it is installed in (K-Chief or AutoChief).