6ES7153-1AA03-0XB0

Technical specifications

Manufacturer

Siemens

Manufacturer part no.

6ES7153-1AA03-0XB0

Type

Interface module

Application

PROFIBUS DP interface for ET 200M

Used with

ET 200M station on PROFIBUS DP

Product type designation

IM 153-1 DP ST

Vendor identification (VendorID)

801Dh

Supply voltage / Rated value (DC)

24 V

Supply voltage / permissible range, lower limit (DC)

20.4 V

Supply voltage / permissible range, upper limit (DC)

28.8 V

external protection for power supply lines (recommendation)

not necessary

Mains buffering / Mains/voltage failure stored energy time

5 ms

Input current / Current consumption, max.

350 mA; At 24 V DC

Input current / Inrush current, typ.

2.5 A

Input current / I²t

0.1 A²·s

Output voltage / Rated value (DC)

5 V

Output current / for backplane bus (5 V DC), max.

1 A

Power loss, typ.

3 W

Address space per module / Inputs

128 byte

Address space per module / Outputs

128 byte

Hardware configuration / number of modules per DP device interface, max.

8

Interfaces / Transmission procedure

RS 485

Interfaces / Transmission rate, max.

12 Mbit/s

1. Interface / automatic detection of transmission rate

Yes

Interface types / Output current of the interface, max.

90 mA

Interface types / Design of the connection

9-pin sub D socket

PROFIBUS DP device / GSD file

(for DPV1) SIEM801D.GSD; SI01801D.GSG

PROFIBUS DP device / automatic baud rate search

Yes

Protocols / Bus protocol/transmission protocol

PROFIBUS DP to EN 50170

Protocols (Ethernet) / TCP/IP

No

Technical documents (1)

• Siemens data sheet 6ES7153-1AA03-0XB0

Key features

• Head module of an ET 200M station on PROFIBUS DP
• Up to 8 S7-300 I/O modules per station
• PROFIBUS address 1 to 125
• 24 V DC supply; 5 V DC to the backplane bus
• Discontinued by Siemens on 1 October 2025; spare part only

About the Siemens 6ES7153-1AA03-0XB0

The Siemens 6ES7153-1AA03-0XB0 is the IM 153-1, the standard interface module of an ET 200M station. Siemens's data sheet gives up to 8 S7-300 modules per station, a PROFIBUS DP address from 1 to 125 and a 24 V DC supply, from which it feeds 5 V DC to the backplane bus. Siemens's data sheet marks it as a spare part. Siemens's route forward is the ET 200MP I/O system.

What is the 6ES7153-1AA03-0XB0 used for?

It sits at the left of an ET 200M rack and connects that rack's I/O modules to the PROFIBUS DP master, usually an S7-300 or S7-400 CPU. If it fails, every module in the station drops off the bus.

Lifecycle and successor

Discontinued: product cancellation (Siemens SiePortal), spare part only.

Before you order

What to photograph or confirm so the right unit is quoted.

Check the order number on the module and note the PROFIBUS address set on it, so the replacement can be set the same way. The station's I/O modules stay in place.